Error when running a satellite model with a 6 DOF joint (simscape multibody)
4 views (last 30 days)
Show older comments
Despite not altering the satellite simulink file in any way I get the following error when trying to run the simulation ....
['satellite_simulink/Ex-Alta 1/6-DOF Joint']: Parameter check for block 'satellite_simulink/Ex-Alta 1/6-DOF Joint' failed.
Caused by:
Insufficient number of outputs from right hand side of equal sign to satisfy assignment.
Component:Simulink | Category:Block error
As I mentioned, I have not changed ANYTHING in the simulink model or attached anything new to the inputs/outputs of the Ex-Alta 1. I have a full MATLAB 2020a install on both my Mac and Surface Pro 3 and both give me the same error.
Any help would be greatly appreciated.
0 Comments
Answers (1)
Steve Miller
on 6 Jun 2021
It appears your model uses a MATLAB expression in the 6-DOF Joint that does not produce an answer compatible with the parameter field. If you upload the model, we can help you fix that expression.
--Steve
0 Comments
See Also
Categories
Find more on Assembly in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!