Is the Xilinx Platform Cable USB II supported for FIL simulation?
2 views (last 30 days)
Show older comments
MathWorks Support Team
on 9 May 2019
Edited: MathWorks Support Team
on 17 Nov 2023
I am using the USB-JTAG interface when trying to perform an FPGA-in-the-loop (FIL) simulation, but have not been able to connect to the board. The error I am getting is:
Did not find any Digilent(R) JTAG cable. Make sure that the cable is connected to your computer.
Failed to initialize the RTIOStream library.
The cable I am using is a Xilinx Platform Cable USB II, and the FPGA board has as Digilent chip for the USB-JTAG interface.
Accepted Answer
MathWorks Support Team
on 17 Nov 2023
Edited: MathWorks Support Team
on 17 Nov 2023
The Xilinx Platform Cable USB II is not supported for FIL simulation.
For FIL simulation, please use the Digilent JTAG-HS2 or JTAG-HS3 programming cables:
For more information on supported connections and cables, please refer to the 'Board Connections' section in the following document:
0 Comments
More Answers (0)
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!