Help needed with simulink onramp Discrete systems

This is task 4 in Discrete systems and I have already enabled the scope on the legend, and still it's showing legend not enabled. It's the same every time I try and I have attempted this twice already. What is wrong?

It is the same in a few other tasks that require legend to be enabled as well. I am unable to submit them even if the legend is clearly enabled.

[Torsten]

Maybe this problem again:

https://uk.mathworks.com/matlabcentral/answers/2178891-why-does-my-answer-to-a-task-show-up-as-incorrect-when-i-have-entered-the-correct-answer-from-the-so?s_tid=srchtitle

?

Thus in short: Try if it helps to clear your browser's cache and cookies.

[Torsten]

@CHANDRA BABU GUTTIKONDA

But in the Scopes Window, isn't the legend already activated ? At least it is shown ...

[CHANDRA BABU GUTTIKONDA]

@Torsten if it is activated the task should be completed but it is showing that the task is not completed . means they have to activate the legend in display properties .

@Garima madam once go back to previous task in which you activated the legend previously and completed and again please repeat it .

Answer 1

[CHANDRA BABU GUTTIKONDA]

IN SCOPE you have settings , click on display and you have to enable the legend in the scope . then it will be activated and the task will be completed

[Carolina]

you are the best thankyou

[CHANDRA BABU GUTTIKONDA]

Thank you so much for your concern @Carolina

[Mandar]

I am experiencing the same problem and have enabled 'Legend' under Settings when I click on SCOPE block.

[CHANDRA BABU GUTTIKONDA]

once check the below two pictures which was shared by me

[Jan-Gerd]

Same problem to me. I run the training in web browser. Now I found the solulion. The legend has to be enabled in the "Property Inspector" on the right side. (ctrl-shift-I)

Answer 2

[CHANDRA BABU GUTTIKONDA]

Answer 3

[CHANDRA BABU GUTTIKONDA]