Trying to create a power factor correction system but no data shows

I've created a system. There's no errors listed, but the data inspector does not show any data and I'm unable to connect the circuit to a scope.

[Hitesh]

Hi @DeSean,

Could you share your simulink file so that we can investigate the root cause this issue ?

[DeSean]

https://matlab.mathworks.com/matlab/24.2.0.2790852/window.html?winId=b513c442-dd90-4730-b17c-be08b1d89ada

[DeSean]

File

[Walter Roberson]

"This application must be launched from MATLAB.

Please close the page and return to MATLAB to re-open the application."

[DeSean]

I am confused by your response Walter.

[Walter Roberson]

Your link to matlab.mathworks.com does not work.

At the time I was testing you had not yet posted the slx file.

Answer 1

[Hitesh]

Hi DeSean,

You need to use "PS-Simulink Converter" block which will convert the physical signal into Simulink output signal. Once done, you can connect it to the "scope" block, and the data will be displayed in the data inspector. I have revised " project.slx" file.

For more information on "PS-Simulink Converter", refer to the below MATAB documentation,

https://www.mathworks.com/help/simscape/ref/pssimulinkconverter.html

Answer 2

[Walter Roberson]

You have Physical Signals. You need to convert them before Scope. https://www.mathworks.com/help/simscape/ref/pssimulinkconverter.html