CAN Vendor

R2026b

CAN hardware vendor for XCP on CAN external mode communication

Since R2026b

Model Configuration Pane: Hardware Implementation / Hardware board settings / Target hardware resources / Groups / External mode

Description

Select the CAN hardware vendor for the host-side CAN interface used during XCP on CAN external mode communication. The available vendors are determined by querying the CAN hardware interfaces connected to the host computer using the Vehicle Network Toolbox™ canChannelList (Vehicle Network Toolbox) function.

The CAN vendor, along with the CAN Device and CAN Channel parameters, identifies the specific CAN hardware interface on the host computer that communicates with Raspberry Pi® during external mode simulation.

Note

  • A Vehicle Network Toolbox license is required to use XCP on CAN external mode.

  • The appropriate CAN hardware support package or vendor-provided drivers must be installed for the connected CAN device to appear in the list.

Dependencies

To enable this parameter, set Communication interface to XCP on CAN and set Host interface to Simulink.

Settings

first available vendor (default) | dynamically populated from connected CAN hardware

Select the CAN hardware vendor from the drop-down list. The list is dynamically populated based on the CAN hardware interfaces connected to the host computer.

Supported vendors

The following CAN hardware vendors are supported through Vehicle Network Toolbox:

  • Vector CANcaseXL

  • Kvaser

  • PEAK-System

Recommended Settings

No recommendation.

Programmatic Use

No programmatic use is available.

Version History

Introduced in R2026b

See Also

(Vehicle Network Toolbox) | | |