CAN Device

R2026b

CAN hardware device for XCP on CAN external mode communication

Since R2026b

Model Configuration Pane: Hardware Implementation / Hardware board settings / Target hardware resources / Groups / External mode

Description

Select the CAN hardware device for the host-side CAN interface used during XCP on CAN external mode communication. The available devices are filtered based on the selected CAN Vendor and are determined by querying the CAN hardware interfaces connected to the host computer using the Vehicle Network Toolbox™ canChannelList (Vehicle Network Toolbox) function.

The CAN device, along with the CAN Vendor and CAN Channel parameters, identifies the specific CAN hardware interface on the host computer that communicates with Raspberry Pi^® during external mode simulation.

Dependencies

To enable this parameter, set Communication interface to XCP on CAN and set Host interface to Simulink.

The available devices depend on the selected CAN Vendor. If you change the vendor, the device list updates to show only devices from that vendor.

Settings

first available device for the selected vendor (default) | dynamically populated from connected CAN hardware

Select the CAN hardware device from the drop-down list. The list is dynamically populated based on the CAN hardware interfaces connected to the host computer that match the selected CAN Vendor.

Device name

The device model name as reported by the canChannelList (Vehicle Network Toolbox) function. The list shows physical CAN hardware devices connected to the host computer.

Recommended Settings

No recommendation.

Programmatic Use

No programmatic use is available.

Version History

Introduced in R2026b