photo

James


Techsource Systems

Active since 2011

Followers: 0   Following: 0

Message

Professional Interests: Control Systems, Physical Modeling, Robotics

Statistics

All
  • Personal Best Downloads Level 2
  • First Review
  • 5-Star Galaxy Level 3
  • First Submission
  • Thankful Level 1
  • First Answer

View badges

Feeds

View by

Question


How do I create tabs for codes already generated using GUIDE?
I've used Matlab GUIDE to construct a GUI and its automated callback functions. I would like to separate them into tabs, how...

9 years ago | 0 answers | 0

0

answers

Answered
how to mate pin with a curved slot ?- Simmechanics
An example model here: http://www.mathworks.com/matlabcentral/fileexchange/50651-cam-gear-actuated-lever

9 years ago | 0

| accepted

Question


how to mate pin with a curved slot ?- Simmechanics
<</matlabcentral/answers/uploaded_files/27244/Picture1.png>> Hi all, I would like to mate the lever (with a pin) to the curve...

9 years ago | 1 answer | 0

1

answer

Answered
Getting "Counter" Simulink block to switch direction?
Hope to get and answer for this too. I manage read the angular velocity from pulse reading but am stuck on how to detect direct...

12 years ago | 0

Question


RTWT Not running real time
Hi, I ran a demo 'Real time vander pol simulation' (type 'rtvdp' on command prompt) on my desktop PC. However, after buildin...

13 years ago | 0 answers | 0

0

answers

Answered
xpctarget ping fails
Additional info: For both PCs I can ping from the DOS environment. Crossover cable is used. Direct connection between host and...

13 years ago | 0

Question


xpctarget ping fails
Hi, I have 2 target PCs - T1 and T2. I configured 'xpcexplr' and boot both PCs. (all configurations are the same but only ...

13 years ago | 3 answers | 0

3

answers

Question


Host target Communication lost once target PC is booted into the xPC environment
Hi all, The communication between my host and target PC is lost everytime I boot the target PC into the xPC environment. I'v...

13 years ago | 3 answers | 0

3

answers

Answered
Turning on grid on ltiviewer
Got it. Need to add 'on' after grid. For bode diagram the command 'grid' is executed twice. Hence, it's turned off. obj = f...

13 years ago | 0

Answered
Turning on grid on ltiviewer
ooooppppss!!! How do I undo accepted answers?

13 years ago | 0

Answered
Turning on grid on ltiviewer
Hi guys, I found a way but still not the best. The grid for Bode diagram is not displayed. Here's what I did; obj = findob...

13 years ago | 0

Question


Turning on grid on ltiviewer
Hi everyone, I displayed 2 systems using ltiview as shown below: load ltiexamples ltiview({'step';'bode';'impulse';'nicho...

13 years ago | 5 answers | 0

5

answers

Question


Error when running HEV model
Hi, I downloaded and tried running a HEV model from here: http://www.mathworks.com/matlabcentral/fileexchange/28441-hybrid-...

13 years ago | 1 answer | 0

1

answer