PMSM Simscape Block - Inertia mask parameter

1 view (last 30 days)
Hi all! :)
I have a doubt about a mask parameter to be set in the following Simscape block (https://it.mathworks.com/help/physmod/sps/powersys/ref/permanentmagnetsynchronousmachine.html). The parameter to be set is the Combined machine and load inertia coefficient J (kg.m2) and I was wondering if it should be set considering the size as motor side or load side? It is not specified anywhere.
In particular, the rotor has its own inertia J_rotor and also an Harmonic Drive (transmission ratio k> 1) is attached to the motor, which has its own inertia J_HarmonicDrive (defined at the harmonic drive input side). I was wondering how the J mask parameter should be set. Should I pass J = J_rotor + J_HarmonicDrive (i.e. sum of motor side inertias) or J = (J_rotor + J_HarmonicDrive) / k ^ 2 (i.e. sum of load side inertias)?
Thanks!

Accepted Answer

Dakai Hu
Dakai Hu on 22 Apr 2021
Moved: Sabin on 24 Dec 2022
Hi Giovanni,
In this case, if you can figure out what J_HarmonicDrive is, I'd use J = J_rotor + J_HarmonicDrive as the inertia parameter for the PMSM block.
  3 Comments
Dakai Hu
Dakai Hu on 17 May 2021
Moved: Sabin on 24 Dec 2022
Torque constant and permanent magnet flux linkage are always evaluated by peak values, whether its phase-to-neutral current or or phase-to-neutral voltage. So to answer your question it should be (N.m / A_peak).

Sign in to comment.

More Answers (0)

Categories

Find more on Specialized Power Systems in Help Center and File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!