Unable to get shared memory page. Make sure that your model either consists a Simulation step or an Analysis step block.

Dear ladies and gentlemen,

i am trying to use MATLAB/Simulink with CANOE. I have integrated CANOE Signal Output blocks in my model. Whenever i start the model i get the following error:

Error reported by S-function 'sigout' in 'xxxxxx/Signal Output/S-Function':

ERROR in block 'xxxxxxxx/Signal Output/S-Function': Unable to get shared memory page. Make sure that your model either consists a

Simulation step or an Analysis step block.

I cant find help for this error so far.

Does anybody know the problem and is able to help me?

Thank you!

Martin Sommer

[Martin Boehme]

Solved it! Problem is that MATLAB R2020a doesn`t work with CANoe 12.0 SP 4 yet. They are working on it. Used MATLAB R2019a and now it works

[伯儒 周]

Thx Bro!

Your answer helps me to solve the same problem.

Thank you again!!!

[Omkar Karve]

Has this problem been solved for 2020b? I am also trying to simulate a model with CANOE 12 signal output box.

[Aditya Vignesh]

@Omkar Karve: Did you try this one?. I am just going to try Canoe on 2020b. I have the same problem on 2019b.

[江波 丁]

@Martin Boehme I am meeting the same problem with MATLAB 2019a&CANoe 11 SP1, could you please help me to check whether they match or not? Thanks a lot.

[Martin Boehme]

For my case it was a problem that Matlab and Canoe version were not compatible. So what you need to do is check, whether your two diferent SW versions are compatible

Answer 1

[Omkar Karve]

I have an update from Vector support on this issue. Attached is the chart showing which Canoe version supports which Matlab version. Hope this helps someone.

[哲]

我这还是不行