Problem with PMSM motor model in Simulink

Good afternoon,

I have developed a Field-Oriented Control for a PMSM motor in Simulink using Simscape Electrical but my motor is not spinning. I have tried applying various speed values but nothing happens. I am applying a step signal from 0 to 300 but the motor speed still doesn't move. My error signal, however, tracks my input as it should. I do not know what has happened. Could someone look at my simulation and tell me what is going on ? My simulink file and screenshots of my signals are attached.

[Mehdi]

Hi Simon ,

did you sort it out your simulation?If Yes , can I have it , please.

[Mehdi]

If you could please email it to me, [e-mail]

Answer 1

[Sabin]

The model uses phase voltages for feedback rather than phase currents. I would advise you to check the IPMSM Velocity Control example for an example about PMSM FOC control.