DTC induction motor drive , changing output torque limits
1 view (last 30 days)
Show older comments
Hello ,
I am trying toi create a simulation for an induction motor of 75 kw , (400V , 50 Hz ,1475 rpm ) using DTC induction motor drive.
I have made the block diagram , according to the example given in help of matlab , I hjave calculated value of K = 3.131 and torque = 485 Nm .
But when i run the simulation , torque is limited to 17.8Nm , as the " output torque limit is set between -17.8 tto 17.8Nm under controller tab of VFD. Now when i try to change the value from 17.8 to any where above this value , it gives me following error
"SPS block 'vfdmodel3/DTC Induction Motor Drive', subsystem 'Speed controller': unable to access expected mask parameter 'ctrl_sat'. Matlab returns the following message: Invalid setting in 'vfdmodel3/DTC Induction Motor Drive/Speed Controller/Zero-Order Hold2' for parameter 'SampleTime'"
Kindly help me in this matter.
0 Comments
Answers (0)
See Also
Categories
Find more on Motor Drives in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!