Error: Unable to locate 'mexopts.bat'
14 views (last 30 days)
Show older comments
I am trying to simulate the file in the following link-
But i am getting a error message "Unable to locate 'mexopts.bat', and therefore cannot determine which compiler to use for simulation builds. Use 'mex -setup' to select a supported compiler." Please somebody suggest some solution of it.
0 Comments
Accepted Answer
Matt Fig
on 11 Sep 2012
I would suggest you follow the advice of the error message! Type this at the command line:
mex -setup
4 Comments
mohamed fathalla
on 13 May 2013
Edited: mohamed fathalla
on 13 May 2013
hi all
i use (mex -setup)
- the output is :
Select a compiler:
[0] None
Compiler:
i enter number 1
the output is
Please select from 0-0
Compiler:
i enter 0 the output is
mex: No compiler selected. No action taken.
i need help
Kaustubha Govind
on 13 May 2013
You need to install a supported compiler if you don't have one already. Look at the last column on this page against your MATLAB version: http://www.mathworks.com/support/sysreq/previous_releases.html
More Answers (2)
Jesse Lee
on 13 Sep 2020
I got the same question,"Unable to locate 'mexopts.bat', and therefore cannot determine which compiler to use for simulation builds.
And I try to enter 'mex -setup' the output is :
Unknown encoding 'cp65001' at D:\Program Files\MATLAB\R2010b\bin\/mexutils.pm line 154
??? Error using ==> mex at 208
Unable to complete successfully.
PS: my version is 2010b. And actually, I've already installed the compiler, which I can see on 2020a
0 Comments
See Also
Categories
Find more on Introduction to Installation and Licensing in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!