How to configure NVRAM Service Component to match Argument of NvMServiceCaller
1 view (last 30 days)
Show older comments
Hello,
I want to make simulations with AUTOSAR blockset which is NvM.
Because I want to save a parameter which is 4array of uint32, I set Argument specification to uint32([1 1 1 1]).
![img1.PNG](https://www.mathworks.com/matlabcentral/answers/uploaded_files/210238/img1.png)
And I made a test harness where NVRAM Service Component is.
![img3.PNG](https://www.mathworks.com/matlabcentral/answers/uploaded_files/210239/img3.png)
Unfourtunately, I have met error messages which are as below
![img2.PNG](https://www.mathworks.com/matlabcentral/answers/uploaded_files/210240/img2.png)
My question is that NVM Service Component can be configured according to the Argument specification of NvmServiceCaller(RealBlock).
To my knowledge, array signal should be saved through invoking NvmServiceCaller.
I hope I would get some answers.
Thanks in advance
- JR
1 Comment
Answers (1)
Stefanie Schwarz
on 3 Jun 2020
The issue you are seeing is a current limitation of our NVRAM Service Component implementation on the simulation side, so that only 'uint8' datatype is supported.
We apologize for the inconvenience. We have an internal report about this and it is planned to improve this in a future release.
0 Comments
See Also
Categories
Find more on AUTOSAR Blockset in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!