How can I operate motor with rs232 and matlab ?

Hello everyone,

I have a MD5-ND14 stepper motor driver, PMC-2HS-232 motion controller and 2 pieces of A8K-M566 5 phase stepper motor from AUTONICS company.

I want to operate stepper motor with matlab. I start with that code

  s = serial('COM3')
  fopen(s)
  ...

But there is a problem about how I can operate the motor. Which codes do I need to write to operate motor ? How can I operate the stepper motor ?

[Miguel D. Martinez]

Did you ever figure out any of the code needed ?

Answer 1

[Shreshth]

Hey Metin,

Please refer to the below discussion link to get the answer to your question.

http://www.mathworks.com/matlabcentral/answers/1685579-control-a-stepper-motor-using-rs232-serial-communication

Thanks.