why does not the board work with STM32-Mat Target?

I have the STM32-MAT/TARGET installed. and followed the read me file. and i have uploaded the generated code. but somehow the board does nothing. i just wanted to blink LED. i am using Matlab

2018b

Answer 1

[Joseph Stalin]

Hello,

If you are using MATLAB, first did you try the simulation works fine by toggling the port. (before downloading it to the STM board.) with a help of scope.

The above step will make sure you configured the right board, IO port as Output..

please check for any warnings while the simulation/build is completed.use the correct target file in the code generation setting.

regards,

Joseph.

[Ahmef Alhajsalem]

hi,

which port should i toggel ? actually i have an Error when i as can be showen in the PDF. but when i change the vendor from Hardware implementation from Stmmicroelectronics to Custum Prozessor then i can build the model but the µc dose nothing

regards