Error when trying to run a c2000 simulink model - CCSv6 and Matlab 2015a

I'm getting an error (please refer to the image) when I'm trying to compile a simple epwm block. I've used xmakefilesetup to configure ccsv6 and matlab 2015b and have installed Embedded Coder Support Package for Texas Instruments C2000 Processors from the internet. Could anyone help me out on how to solve this issue? It seems that Matlab cannot access the source files.

Answer 1

[Venkatesh Chilapur]

Hi,

xmakefilesetup is for using the idelink.tlc workflow, and using idelink.tlc is not recommended and has been discontinued. You should be using ert.tlc with CCS to help you work with the board as needed.

If you need to reconfigure the support package, use the command targetupdater.

Regards,

Venkatesh C

[Raghu Raman]

Could you please advise on how to use configure the ert.tlc workflow? What command should one use to configure it? I've used 'targetupdater' before to connect matlab to the support package and the toolchain.

Answer 2

[Venkatesh Chilapur]

Hi,

https://www.mathworks.com/help/releases/R2016a/supportpkg/texasinstrumentsc2000/ug/coder-target-pane-texas-instruments-c2000-processors.html

http://www.mathworks.com/help/supportpkg/texasinstrumentsc2000/ug/install-support-for-c2000-processors.html?refresh=true

https://www.mathworks.com/matlabcentral/answers/124142-what-is-the-difference-between-ert-tlc-model-and-idelink_ert-tlc-model#answer_177303?s_tid=prof_contriblnk

These links can be helpful.

Regards,

Venkatesh C

[Raghu Raman]

Thank you. Following the instructions for setup and run the epwm block stills show an error. Please see the attachment. It would really be helpful if there is a tutorial or a sequence of instructions for the setup. Would really appreciate if you can help.