set initial value for a signal and then rewrite it

Hi, I have a loop in which an observer observe the states and then backward it to a controller. There need to be an initial value for one signal. That signal will start the simulations and gets other values in the loop. Does anyone know how to set the initial value for such system in Simulink?

Answer 1

[Jyotish Robin]

Hi!

As far as I understand you are looking for a way in which you can specify the initial value for a signal in a Simulink model.

Probably the IC block will fit your needs.

The IC block sets the initial condition of the signal at its input port, for example, the value of the signal at the simulation start time (t_start). The block does this by outputting the specified initial condition when you start the simulation, regardless of the actual value of the input signal. Thereafter, the block outputs the actual value of the input signal.

Hope this helps!

Regards,

Jyotish

[Peppe]

Exactly what I looked for. Thank you