Apply several properties to subplots without duplicated lines

Hi, I would like to make the below more succinct.

As

set(findobj(gcf,'type','axes'),'FontName','Calibri','FontSize',11,'FontWeight','Bold', 'LineWidth', 1,'layer','top');grid on

is written several times, I would like to know how to apply properties to all subplots all at once.

figure(1)
set(gcf,'position',[500 200 1000 600])
subplot(311)
stairs(A,B,'markersize',2,'marker','*','linewidth',1)
xlabel('Frequency (Hz)'),ylabel('Amplitude')
set(findobj(gcf,'type','axes'),'FontName','Calibri','FontSize',11, ...
'FontWeight','Bold', 'LineWidth', 1,'layer','top');grid on

subplot(312)
stairs(C,D,'markersize',2,'marker','*','linewidth',1)
xlabel('Frequency (Hz)'),ylabel('Amplitude')
set(findobj(gcf,'type','axes'),'FontName','Calibri','FontSize',11, ...
'FontWeight','Bold', 'LineWidth', 1,'layer','top');grid on

subplot(313)
plot(E,F,'MarkerSize',1,'LineWidth',1)
xlabel('Time [ms]'),ylabel('Amplitude')
set(findobj(gcf,'type','axes'),'FontName','Calibri','FontSize',11, ...
'FontWeight','Bold', 'LineWidth', 1,'layer','top');grid on

Thank you in advance!

Answer 1

[Sangeetha Jayaprakash]

You can just call the line "set(findobj(gcf,'type','axes'),'FontName','Calibri','FontSize',11,'FontWeight','Bold', 'LineWidth', 1,'layer','top');grid on" after all the subplots have been plotted as follows:

figure(1)
set(gcf,'position',[500 200 1000 600])
subplot(311)
stairs(A,B,'markersize',2,'marker','*','linewidth',1)
xlabel('Frequency (Hz)'),ylabel('Amplitude')

subplot(312)
stairs(C,D,'markersize',2,'marker','*','linewidth',1)
xlabel('Frequency (Hz)'),ylabel('Amplitude')

subplot(313)
plot(E,F,'MarkerSize',1,'LineWidth',1)
xlabel('Time [ms]'),ylabel('Amplitude')

set(findobj(gcf,'type','axes'),'FontName','Calibri','FontSize',11, ...
'FontWeight','Bold', 'LineWidth', 1,'layer','top');grid on

Here, "findobj(gcf,'type','axes')" will find all the axes which correspond to the current figure handle.

[Creatlee]

Dear Sangeetha,

Thank you for your answer. This is what I was looking for!! Even I may use several other properties of figure based on your answer. Thank you! Have a nice day!

Answer 2

[Lukas]

For example: to switch the grid on on all the axes in a current figure (gcf)

arrayfun(@(x) grid(x,'on'), findobj(gcf,'Type','axes'))

The functio @(x) grid(x,'on') can be replaced with something more complex.