How to link requirements using Custom ID rather than Index

We have requirements in a third party tool that we want to link to a model but we still need to manage them in the third party tool. We import the requirements into the Requirements Editor by using reqif import. When we re-import the requirements, due to a change that removes requirements, adds requirements (other than at the end) or otherwise re-orders requirements, then the existing link information cannot be re-used. How can we have the link information be maintained on the basis of the CustomID rather than on the ID?

[Josh Kahn]

HI @Callum,

Can you help me understand the issue? Is the problem that you want to transfer links from the old requirement set to the new requirement set when doing a fresh import from REQIF? Is the update workflow not working properly?

https://www.mathworks.com/help/slrequirements/ug/update-imported-requirements.html

Josh

[Callum]

Thank you, unusre how I managed to miss that page when searching through the documentation.

From a few tests I have run I have found that using update, under Requirements Interchange In the right pane is working perfectly.

[Josh Kahn]

Awesome!

Answer 1

[Josh Kahn]

The solution is to use the update button in the requirements editor 🙂

https://www.mathworks.com/help/slrequirements/ug/update-imported-requirements.html