TI Radar Toolbox: mmWave Radar Setup error when trying to Test Connection

Hello,

I have a IWRL6432BOOST EVM. When running mmWaveRadarSetup during Enable Functional Mode>Verify connection>Test Connection

I receive the following error:

The binary is being Successfully loaded with the correct COM port. I have no issue when loading the binary with TI Visualizer. So, I'm now wondering:

1) What binary is mmWaveRadarSetup loading? There is no option which binary to load.

2) I have multiple SDK versions, 05.05.03.00, 05.03.00.02, 05.02.00.02. Will any of these SDK versions work?

When I try to run mmWaveRadar() afterwards I get the following:

From the previous error:

• the device is connected correctly
• I tried the three binaries listed above with error resulting from each
• the device is in functional mode
• the device was rebooted and reset

If you can provide any insights or guidance with what's going on it will be much appreciated.

Thanks

Khan

Answer 1

[Gayatri Menon]

Hi

The issue might be due to a mismatch between the hardware, SDK, and the versions supported by the MATLAB support package. Based on the error you're seeing, it’s possible that your board has a different chip version, which may not be fully compatible with the support package. Please reach out to technical support for help with next steps.

Thanks

Gayatri

[Khan]

Hello Gayatri,

Thanks for the response. I will reach out to technical support. I appreciate the help

R/Khan