The encoder counter and speed display are wrong

I'm using R2024a and Embedded Encoder Support Package for Infineon AURIX TC3x Microcontrollers inside the add on.

And using the encoder block and running in KIT_A2G_TC387_5V TFT board ,and use scope to observe the output.

The results and settings are as shown below.

1.hardware setting

2-1 encoder setting

2-2 encoder setting

3.scope setting

4.result

from top to the bottom is count,direction,and rad/s.

[UDAYA PEDDIRAJU]

Can you share the files? I can't replicate the situation without the files.

Answer 1

[UDAYA PEDDIRAJU]

Hi Fred,

To address the incorrect encoder counter and speed display:

1. Check Hardware Configuration: Ensure all hardware settings are correctly configured for the KIT_A2G_TC387_5V TFT board.
2. Verify Encoder Settings: Double-check the encoder settings, including resolution and signal type, to match your hardware specifications.
3. Scope Configuration: Review the scope settings to ensure proper signal scaling and time base alignment.
4. Calibration: If discrepancies persist, calibrate the encoder and verify connections to rule out hardware issues.

These steps should help resolve the inaccuracies in your encoder counter and speed display.