Error:External Mode Open Protocol Connect command failed Caused by: Could not connect to target application: XCP internal error: timeout expired, in response to XCP CONNEC

External Mode Open Protocol Connect command failed

Caused by:

• Could not connect to target application: XCP internal error: timeout expired, in response to XCP CONNECT command

How To fix this problem?

[Vamsi krishna]

Did you try to fix this ? I'm getting the same error on f28379d control card. However, this error only appears in the "Monitor and Tune" mode and not during "Bulid, Deplay & Load"

[Abinesh]

Vamsi krishna

Did you solve this issue same problem is with me also how to resolve this issue.

Error:External Mode Open Protocol Connect command failed

Caused by:

Could not connect to target application: XCP internal error: timeout expired, in response to XCP CONNECT command

Error:Unable to connect to the 'TI Delfino F28379D LaunchPad' target for 'mcb_open_loop_control_f28379d'.

[Jorge]

Try to reset the device. For me it worked xd

Answer 1

[Venkat Siddarth Reddy]

Hi Chiang,

Refer to the following post regarding this query, since this consolidates various approaches in solving the issue:

https://www.mathworks.com/matlabcentral/answers/2019856-error-could-not-connect-to-target-application-xcp-internal-error-timeout-expired-in-response-to?s_tid=answers_rc1-1_p1_MLT

I hope it helps!

[CHIANG]

"I didn't encounter any XCP issues with the following model."

Using the same environment.

WHY?

[Noman Nosher]

you are lucky