Clear Filters
Clear Filters

variable duty ratio to a switch at different time intervals

8 views (last 30 days)
I want to supply a gate pulse to an IGBT switch in DC-DC converter with a duty ratio of 40% from 0 to 2 seconds and 2 to 4 seconds with simulation time of 6 seconds and i want to disconnect the gate pulse to switch from 4 to 6 seconds. how to do this in simulink. The switching frequency of IGBT switch is 20 kHZ.
  6 Comments
Fangjun Jiang
Fangjun Jiang on 12 Apr 2024
@Manikanta Aditya, which Pulse Generator block are you referring to? I didn't find the place to "Define Variable Duty Ratio in Pulse Type Attributes".
Manikanta Aditya
Manikanta Aditya on 13 Apr 2024
I meant the Pulse Generator block in Simulink that allows defining a variable duty ratio based on time.

Sign in to comment.

Accepted Answer

Fangjun Jiang
Fangjun Jiang on 12 Apr 2024
I assume this is in Simulink. You can use an AND logic block or Product block to multiply two signals. One is the regular 40% duty cycle PWM all the time, the other is this On/Off signal based on pre-determined timing or based on event by other Simulink signal.
  3 Comments
Fangjun Jiang
Fangjun Jiang on 12 Apr 2024
You could use a Signal Builder block. Or use a Switch block, before t<4, pass the PWM. After that, switch to 0.

Sign in to comment.

More Answers (0)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!