how to model an air turbine start system in Simulink?

I have planed to simulate a pneumatic Air Turbine Starter system in Simulink but I don't know to simulate a pneumatic Air Turbine Starter system with Simulink? Could you please help me about this issue?

Source of air is from Load compressor.

Air Mass Flow Rate = 70 kg/min

Air Prressire = 40 psi

Torque Out Put = 1440 N-m

Answer 1

[MathWorks Simscape Team]

Hi Vincent,

You should start by doing the Simscape Onramp to learn the basics of Simscape.

Then, if you look at these examples, you will see many of the components you will need

https://www.mathworks.com/help/sps/ug/wind-turbine.html

https://www.mathworks.com/help/simscape/ug/brayton-cycle-gas-turbine-with-custom-components.html

I recognize these are not an exact match to the type of turbine you are modeling, but it shows how to use many of the components you will need.

--Steve