TMDSCNCD28335: How to use External Mode is not running in SImulink
2 views (last 30 days)
Show older comments
does anybody have used TI TMDSCNCD28355 control card successfully in external mode using simulink, then let me what is the procedure because i am getting following error while connecting it using simulink
https://in.mathworks.com/matlabcentral/answers/1732385-simulink-external-mode-not-working-on-texas-instruments-f28335-control-card
0 Comments
Answers (1)
Muskan
on 22 Jan 2024
Hi Shibu,
The error message mentioned by you indicates that communication was interrupted between the host and target, or that communication was never started at all.
There are a number of possible causes. Please confirm the switch/jumper settings being used on the device, if applicable. These should match the settings spelled out in the TI User Guide for the device, and on the Set up Serial Communication documentation page linked below.
0 Comments
See Also
Categories
Find more on Simulink Functions in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!