Getting error in Simulink Onramp 13.1 Task 5 How to fix it?

Answer 1

[atharva]

Hey Kaushik,

I understand that you are getting the error "Does the connected signal meet the requirement" .

To resolve the error ,try the following steps -

1. "h" signal has to connect to both signal assessment and the middle input port of the switch block.
2. set the initial condition of Integrator 1 to 60 m.
3. set the initial condition of Integrator 2 to -10m.

I hope this helps!

Answer 2

[Roshan]

From your simulation plot, the run time is 2.5 seconds. Set it to exactly 10 seconds to match the task requirements. also, connect h to the Single Assessment block.