How can I extract data from the hardware simulation to excel from time 0 seconds ?

I'm unable to extract the data from hardware simulation to excel from time 0 seconds. I'm getting values from time 60 seconds insted of 0 seconds.

[Monika Jaskolka]

Can you provide the data that you are working on and what commands you have tried?

[Marabathina Maheedhar]

Its hardware simulation, i didn't use any commands, company designed that simulink in matlab

Answer 1

[Saurabh]

Hello Marabathina,

There might be several possible reasons for the simulation to capture the result from 60 seconds instead of 0 seconds:

• Check if the simulation start time is set to 0 seconds in the configuration parameters under the ‘solver’ options.
• And assuming you are using a data logging feature or a To Workspace block in Simulation, make sure it’s configured to start logging at the begging of the simulation.

These are a few of the possible reasons that I can think of that can solve your issue.

For More information you can refer this documentation to understand more about the start time inside the solve pane of configuration parameters: https://in.mathworks.com/help/simulink/gui/starttime.html

I hope this was helpful!!

Best regards,

Saurabh Singh