how I can get 2 mpu6050 data from arduino to matlab!
2 views (last 30 days)
Show older comments
hi!! I'm using 2 mpu6050 that connected in parallel to my arduino. I need to get the data, analysis it ,and make graph with this data. how to do it?!?!?
thanks:) Reut
0 Comments
Answers (2)
Zafb
on 18 Sep 2014
Hi, I am trying the same with no success so far. However, for plotting, I have used the PLX-Daq quite successfully. http://gadgetmakersblog.com/top-5-arduino-tools/
Regards,
0 Comments
Gayatri Menon
on 31 Jan 2020
Hi,
From R2019a, to read the data from mpu6050 connected to arduino, the below code can be used:
Please refer the below link for more information:
a = arduino
imu = mpu6050(a);
accel = readAcceleration(imu);
gyro = readAngularVelocity(imu);
For connecting two mpu6050, you need to have different I2C address for each device.This can be done by connecting AD0 pin of one of the sensor to logic level HIGH(0x68 is the default address, if AD0 is high, the address will be 0x69).Then you can specify the addresws of I2C device using a Name value pair.
imu1 = mpu6050(a,'I2CAddress','0x68')
imu2 = mpu6050(a,'I2CAddress','0x69')
Hope this helps,
Thanks
Gayatri
2 Comments
haziqah zaifuddin
on 22 Oct 2020
hi, is this code will directly provide acceleration value? because intially the data pruduced by mpu6050 is in (g) unit
Gayatri Menon
on 23 Oct 2020
See Also
Categories
Find more on MATLAB Support Package for Arduino Hardware in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!