MATLAB Answers

problem with real time udp in xPC target 5.5 when using the Intel-Gigabit ethernet adapter

2 views (last 30 days)
fatima
fatima on 21 Nov 2013
Commented: Suneesh on 6 Dec 2013
hello! I have two network adapters in my xPC target which both of them are Intel-Gigabit(82540EM). when I try to boot the system and load my model on target machine, I have no problem. but when I run the model, It stopped in running mode and the connection between host and target failed. (TCP/IP connection disconnected). I check the setting of the network configuration and set it's parameters as follows: IP address : 192.168.4.105 subnet Mask : 255.255.255.0 Gateway : 192.168.4.1 Ethenet driver : Intel Gigabit PCI bus: 2 Slot: 3 when I changed the secondary adapter card and useed a 8255x card, program was completely executed and had no problem. but I need to use Intel-Gigabit as a secondary adapter. please help me to find the problem. best regards.
  1 Comment
Suneesh
Suneesh on 6 Dec 2013
1. Do you see an error message? 2. When you say "secondary adaptor" are you using this for realtime Ethernet or UDP? In which case they there needs to be appropriate init blocks and the (probably incorrect)settings in those blocks could be causing a problem.

Sign in to comment.

Answers (0)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!