closed loop in the c2000 platfrom using MAtlab
i am confused about how to run as a closed loop. how to do closed-loop control of phase shift using matlab. i am using c2000 embedded by Matlab.
19 Comments
Time Descending
Hi friend,
We do have a couple of examples that explain how to perform closed loop control using c2000 platform. These are closed loop motor control, dc-dc buck converter control, solar pv inverter control, etc.
More details can be found at following location: https://in.mathworks.com/help/supportpkg/texasinstrumentsc2000/modeling.html
If you are looking for something specific, then I'd request you to provide more details.
Thanks for the reply. I needed to off SW1 in the control card and short the jumper.
My question is I used 50 bit. What would be dead time.
Moreover using in external it always give error in between .
Hi buddy,
I think we need more information on your questions, as this thread is too long to keep track of.
Would encourage you to please write more details to us at: support@mathworks.com
