Audiocapture objects error after connected to Raspberry Pi
4 views (last 30 days)
Show older comments
Hi all, I am very new to using Matlab to interface with Raspberry Pi and I am trying to use its audio platform.
I have installed Matlab coder and the hardware supporting package.
But I am getting this error when I tried to run audiocapture:
audiocapture and audioplayer are supported only for code generation
I am runinng on Macbook and xcode is updated too.
Where should I look into for this problem? Any help is appreciated
0 Comments
Accepted Answer
Yihan Hu
on 21 Oct 2020
2 Comments
Jon Dana
on 23 Oct 2020
Edited: Jon Dana
on 23 Oct 2020
I had the same issue and found that the following information is missing from the Raspberry Pi Audio tutorial:
- You need the Matlab Coder add-on
- You need to save the uncommented "raspi_pitchshiftdeployment()" function in a file
- Check available audio resources on the Pi with "system(rpi, 'aplay -l)"
Note:
- The demo was observed to stop after a few minutes. This is likely controlled by "for k = 1:3000"
More Answers (0)
See Also
Categories
Find more on MATLAB Support Package for Raspberry Pi Hardware in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!