Updating simulink block parameter as the simulation runs.
2 views (last 30 days)
Show older comments
computer12345
on 6 Jul 2020
Commented: computer12345
on 8 Jul 2020
Hello!
I'm new to Matlab and I'm wondering if this is possible.
I have a custom block with a mask that takes in 3 user-input parameters. One of the parameters is frequency and I want to vary the frequency with time while the simulation is running. I looked all over the internet and I found a suggestion to replace the frequency parameter with a workspace variable array, with the array setup as [time1 value1;time2 value2; time3 value3....]. I tried this, but I got an error saying that the there was an issue with the blocks in the subsystem reading the arrays properly. I placed this code into the InitFnc callback.
Am I doing going about this correctly? If so, what do I modify to ensure that the frequency input ports are correctly reading an array input?
If not, is there a different way I can go about changing the frequency with time? I am trying to do everything using a script, rather than including blocks like time steps since the block is masked.
Thanks!
0 Comments
Accepted Answer
Fangjun Jiang
on 7 Jul 2020
setting array value as [time1 value1;time2 value2; time3 value3....] works for signal, not for parameters. Use this approach instead
set_param(YourModel, 'SimulationCommand', 'pause');
set_param(YourBlock, parameter, value);
set_param(YourModel, 'SimulationCommand', 'continue');
5 Comments
Fangjun Jiang
on 8 Jul 2020
It has nothing to do with other functions. The Assertion block is calling PauseFcn, so you have to have a .m script called PauseFcn.m in your MATLAB path.
More Answers (0)
See Also
Categories
Find more on Electrical Sensors in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!