Digraph With Node Labels From CSV Data
4 views (last 30 days)
Show older comments
Kamal Premaratne
on 28 Nov 2019
Commented: Kamal Premaratne
on 4 Dec 2019
I am trying to do some spectral clustering on a digraph, specifically, the digraph corresponding to C Elegans Adult Male, using the edge list available at wormwiring.org. I downloaded the csv file as column vectors, VarName1 (categorical array of the start node of an edge), VarName2 (categorical array of the end node of the edge), VarName3 (double array of the weight of the edge), and VarName4 (categorical array of the type of connection, chemical or electrical). All are of size 5107 x 1. For the moment, I am ignoring VarName4. As an example, here are the first 10 entries of VarName1-3:
>> [VarName1(1:5) VarName2(1:5)]
ans =
5×2 categorical array
I1L I2L
I1L I3
I1L I5
I1L I6
I1L M2L
>> VarName3(1:5)
ans =
10
3
2
1
3
I would like to construct a digraph from this data where the nodes are labeled as I1L, I2L, I3, etc. I tried
>> G = digraph(VarName1, VarName2, VarName3)
which spits out
Error using matlab.internal.graph.constructFromEdgeList (line 98)
Node IDs must both be numeric or both be character vectors.
Error in digraph (line 273)
matlab.internal.graph.constructFromEdgeList( ...
As a next step, I extracted the unique node labels as
>> UniqueLabels = unique([unique(VarName1); unique(VarName2)])
which is a categorical array of size 526 x 1, and then tried
>> G = digraph(VarName1, VarName2, VarName3, UniqueLabels)
which spits out
Error using matlab.internal.graph.constructFromEdgeList (line 62)
Node information must be a cell array of character vectors, a table, or a number of nodes.
Error in digraph (line 273)
matlab.internal.graph.constructFromEdgeList( ...
I would very much appreciate any ideas/suggestions that you might be able to provide. Thank you.
-- Kamal
0 Comments
Accepted Answer
Raunak Gupta
on 4 Dec 2019
Hi,
From the error message I can understand that you are using MATLAB R2018b or earlier release. From R2019a onwards digraph supports categorical arrays as input to source nodes and target nodes vector. So, you may try updating the MATLAB with latest release.
If you are unable to do it straightaway, I suggest converting the categorical array to cell arrays as they are supported in release R2018b and earlier ones. You may find cellstr useful for converting categorical array to cell array. The below command should work.
G = digraph(cellstr(VarName1), cellstr(VarName2), VarName3);
More Answers (0)
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!