Error using SimBiology model over command line

I have a model built in SimBiology, it works in SimBio GUI i.e. runs without error and live plots. But when I tried running same model with MATLAB command line it's giving empty result.

sbioloadproject('model.sbproj')

[time, x, names] = sbiosimulate(m1);

time, x, names are empty variables.

My quick analysis of problem,

In SimBio GUI I have set the AbsoluteToleranceStepSize to 1e-5, but that I cannot verify with getconfigset(m1) on command line/script. Since run fails in SimBio GUI if that value is set to default [].

Is there a way to set it in command line also, if that's the issue.

Answer 1

[Arthur Goldsipe]

Hi,

I would expect the setting you see for AbsoluteToleranceStepSize in the GUI to be the same as you see in the command line. If your model is in variable m1, you can confirm this with the following MATLAB code:

cs = getconfigset(m1)
cs.SolverOptions.AbsoluteToleranceStepSize