algebric loop error while running
7 views (last 30 days)
Show older comments
An error occurred while running the simulation and the simulation was terminated Caused by: Simulink cannot solve the algebraic loop containing 'untitled/PV Panel/PV Array/Diode Rsh/Product5' at time 0.0004 using the TrustRegion-based algorithm due to one of the following reasons: the model is ill-defined i.e., the system equations do not have a solution; or the nonlinear equation solver failed to converge due to numerical issues. To rule out solver convergence as the cause of this error, either a) switch to LineSearch-based algorithm using set_param('untitled','AlgebraicLoopSolver','LineSearch') b) reducing the ode23t solver RelTol parameter so that the solver takes smaller time steps. If the error persists in spite of the above changes, then the model is likely ill-defined and requires modification.
0 Comments
Answers (1)
Birdman
on 7 May 2018
Add a Delay or Unit Delay block in front of the Product5 block in your model to solve the issue.
0 Comments
See Also
Categories
Find more on General Applications in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!