How to synchronize two datasets with different AND varying sampling rate?
3 views (last 30 days)
Show older comments
I have the data sets, Data1 and Data2 like below:
Data1.t % vector with timestamps e.g. [0.1, 0.4 2 2.3 4 4.5 4.7 etc...]
Data1.data % The voltage measured of a 0.1 Hz triangle function at the times specified above.
and:
Data2.data % the same 0.1 Hz triangle function but measured at different times than in Data1.t
The problem is that I want to figure out the time at which Data2 was sampled, i.e. Data2.t (there is at least 10 samples per period)
I was thinking of using something like
Data2.t=interp(Data1.data(start_index_n:stop_index_n),...
Data1.t,...
Data2.data(start_index_n:stop_index_n))
If I'm lucky I can find the
start_index_n
for each period "n" in both Data1.data and Data2.data with some peakfinder-function… and then cycle through all the recorded periods.
(I started writing this as a question but as I was writing I realised how I could approach the problem. So this post is mainly to help others)
0 Comments
Answers (0)
See Also
Categories
Find more on Get Started with MATLAB in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!