how to run a Simulink model in a Matlab M file in this way?

I have simulink model "Mod_Sim" in simulink with an input port "inp" and an output port "out". I want to send inputs to this model, simulate it and then take the corresponding outputs at every sampling time "Ts". I want to simulate this model in this way for "N" time steps (in terms of Ts).

More specifically, I want the following implementation:

At a given time step "k", I will have input u(k) (from some other source). Then, I want to apply this input to Mod_Sim and get the corresponding output y(k) from the model. I want to repeat this for N time steps.

How can I do such an implementation?

I will be happy for helps.

Answer 1

[Azzi Abdelmalek]

Use set_param

[E U]

Dear Azzi, could you please write a few lines on how this will be done? Your answer was very short and I did not figure out how to implement this with set_param.