During USRP setup, I encounter the error 'connect to a non-internet device,' and I can't proceed. Why is this happening, and how can I resolve it?
7 views (last 30 days)
Show older comments
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1512764/image.png)
0 Comments
Accepted Answer
atharva
on 18 Oct 2023
Hey Jack,
I understand that when you are using ‘’Communications Toolbox Support Package for USRP Radio’’, the status observed is ‘Connected to a non-internet device’.
Please follow the below workaroud to resolve your issue-
Approach 1:
Uncheck the option "I want to configure my computer's network interface manually" in step2 specified on this page https://in.mathworks.com/help/supportpkg/usrpradio/ug/configuring-host-computer-for-ethernet-based-radio-connection.html#responsive_offcanvas
Approach 2:
Follow the below mentioned steps to resolve the issue:
1. Go to Control Panel --> Network and Internet --> Network Connections
2. Double click and open the interface connection for the radio
3. Go to properties and then double click "internet protocol version 4 (TCP/IPv4)
4. Choose the option "Use the following address", and enter some IP address like 192.168.60.60, and set the subnet mask to 255.255.255.0. Click ok and close the dialog box.
Now run the hardware setup in MATLAB, as done earlier.
The steps from 1 to 10 under the section " Configure Ethernet Connection Via Windows Network Connections App" are also mentioned here on this page
I hope this helps!
2 Comments
wenjun
on 22 May 2024
hi jack, Have you solved the problem of "Connected to a non-Internet device"? I have the same problem
Looking forward to your reply
More Answers (0)
See Also
Categories
Find more on Communications Toolbox in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!