I had the same problem with an electrical field Ex, Ey, Ez and contacted the Mathworks support. They gave me this comprehensive answer:
The reason this is occurring is that your 'Ex', 'Ey', and 'Ez' matrices are all NaN at the origin (index 21,21,21). When "streamslice" tries to interpolate near the origin, it uses this NaN value, and it will not display a slice if there is a NaN value in the slice.
In order to avoid this issue, you can either avoid defining your grid at the origin, or you can use the 'spline' method instead of 'linear' as it will ignore all NaN values when performing interpolation. Note that for 'cubic' you could not use '0.1' because it would use the NaN value at the origin as an interpolating point for that slice.
If you do use 'spline', then you will see many warnings about the NaN values. You can avoid these warnings with the command:
I suggest you turn these warnings back on with this command once you are done: