How to get signal from target computer to oscilloscope

Dear all,

I am currently testing my xPC Target components connection to know if all of them are working properly. On my target computer, I have plugged in an I/O card NI PCI-6229. I built a simple model on the host computer. A signal generator that generates sine wave. I bulit the model, connect to the target computer and observe the sine wave signal on the target computer monitor.

Now, I want to observe the sine wave using an oscilloscope. The oscilloscope is connected to the I/O card but when I run the model, I cannot see the sine wave on the oscilloscope. Is there any command that we have to type in order to be able to use the plugged-in I/O card?

[Suneesh]

As far as I know, no other commands are necessary.

1. What block are you using for the output?

2. Can you attach the model that you are using?