Select a value from the list of master clock frequency to obtain an SPI clock frequency.
Default:
4000
8000
, 4000
,
2000
, 1000
,
500
, 250
,
125
Select an SPI mode for data transmission.
Default:
Mode 0 - Clock Polarity 0, Clock Phase 0
Mode 0 - Clock Polarity 0, Clock Phase
0
Mode 1 - Clock Polarity 0, Clock Phase
1
Mode 2 - Clock Polarity 1, Clock Phase
0
Mode 3- Clock Polarity 1, Clock Phase
1
Select the bit order for transmissions.
MSB first
to send the most significant bit first for
transmission or select LSB first
to send the least
significant bit first for transmission.
Default:
MSB first
MSB first
– Send the most significant bit
first for transmission.
LSB first
– Send the least significant bit
first for transmission.
The Slave Select (SS) pin that your SD card shield uses for SPI communication with the connected SD card. Do not make any modifications if you are using Arduino® MKR Zero board. As the MKR Zero board has an in-built SD card slot, the support package auto-populates the SD Card SPI SS pin parameter.
Default:
4
The SS pin that your CAN shield uses for SPI communication with the hardware.
Default:
3