Configure and View Diagnostics
Simulink® provides diagnostic messages when certain conditions are detected during a Simulink operation on a model. The diagnostic messages are captured under error, information, or warning categories.
The diagnostic messages you encounter during a command-line operation are
displayed in the Command Window, while those you encounter during a
Simulink user interface operation are displayed in the Diagnostic
Viewer . For example, if you use the command
at the MATLAB® command prompt to simulate a model, the diagnostics messages
are displayed in the Command Window. However, if you run a simulation from
the Simulink Toolstrip, the diagnostic messages are displayed in the
You can customize the diagnostic messages, and also customize the conditions the software checks to either produce errors or warnings.
The diagnostics for model are displayed in the Diagnostic Viewer user interface. To know more about the diagnostic viewer, see the topic View Diagnostics.
You can also add Model Verification blocks to your model, to check the condition of specific signals. To know more about Model Verification, see topics listed under Run Model Advisor Checks.
|Display diagnostic information of Simulink system|
|Restore diagnostic warnings to a specific block, subsystem, or model|
|Suppress a diagnostic from a specific block|
| Return |
|Suppress diagnostic messages from a specified block|
- View Diagnostics
View and diagnose errors and warnings with the Diagnostic Viewer.
- Systematic Diagnosis of Errors and Warnings
Identify and locate errors and warnings systematically.
- Report Diagnostic Messages Programmatically
sldiagviewerfunctions to generate, display, and log diagnostic messages.
- Suppress Diagnostic Messages Programmatically
Suppress and restore diagnostic messages programmatically.
- Customize Diagnostic Messages
Customize error messages to display text and hyperlink.