Connected IO Simulation

Modify model design and monitor data from peripherals in a near real-time environment

Connect your Simulink^® model directly to the supported Arduino^® hardware for live I/O data exchange for rapid prototyping.

Simulation with connected IO is an intermediate step in the Model-Based Design workflow that bridges the gaps between simulation and code generation. It enables your Simulink model to communicate with the Arduino hardware before you deploy the model.

Model Settings

Model Configuration Parameters for Simulink Support Package for Arduino Hardware

Topics

Communicate with Hardware Using Connected IO
Get data from hardware peripherals before deploying the Simulink model on the hardware.
Set Up a Wi-Fi TCP/IP Connection with Connected IO in Simulink
Establish a Wi-Fi TCP/IP connection and simulate model in the connected IO mode.
Set Up a Wi-Fi UDP Connection with Connected IO in Simulink
Establish a Wi-Fi^® UDP connection and simulate model in connected IO mode.
Measure Servo Motor Shaft Angle Using Device Driver Block in Connected I/O
Enable Connected I/O on a Simulink System object™ block that contains hardware-specific code allowing access to hardware-specific features.

Featured Examples

Prepare, Configure, and Run Simulink Model for Different User Workflows on Arduino

Use the Simulink® Support Package for Arduino® Hardware to prepare, configure, and run a Simulink model for different workflows such as PIL simulation, Connected IO, Monitor and Tune External mode, real-time code profiling, and deployment.

Open Model

How useful was this information?

Unrated 1 star 2 stars 3 stars 4 stars 5 stars