Perform basic peak analysis. It will help you answer questions such as: How do I find peaks in my signal? How do I measure distance between peaks? How do I measure the amplitude of peaks of a signal which is affected by a trend? How do I find peaks in a noisy signal? How do I find local minima?
Introduction to MIMO Systems
Multiple-Input-Multiple-Output (MIMO) systems, which use multiple antennas at the transmitter and receiver ends of a wireless communication system. MIMO systems are increasingly being adopted in communication systems for the potential gains in capacity they realize when using multiple antennas. Multiple antennas use the spatial dimension in
Perform classification using discriminant analysis, naive Bayes classifiers, and decision trees. Suppose you have a data set containing observations with measurements on different variables (called predictors) and their known class labels. If you obtain predictor values for new observations, could you determine to which classes those
Measuring Signal Similarities
Measure signal similarities. It will help you answer questions such as: How do I compare signals with different lengths or different sampling rates? How do I find if there is a signal or just noise in a measurement? Are two signals related? How to measure a delay between two signals (and how do I align them)? How do I compare the frequency content of two signals?
Counterparty Credit Risk and CVA
Compute the unilateral credit value (valuation) adjustment (CVA) for a bank holding a portfolio of vanilla interest-rate swaps with several counterparties. CVA is the expected loss on an over-the-counter contract or portfolio of contracts due to counterparty default. The CVA for a particular counterparty is defined as the sum over all points in time of
Designing a Guidance System in MATLAB and Simulink
Use the model of the missile airframe presented in a number of published papers (References ,  and ) on the use of advanced control methods applied to missile autopilot design. The
Modeling a Fault-Tolerant Fuel Control System
Combine Stateflow® with Simulink® to efficiently model hybrid systems. This type of modeling is particularly useful for systems that have numerous possible operational modes based on
CoMP Dynamic Point Selection with Multiple CSI Processes
How multiple Channel State Information (CSI) processes provide the network with feedback for Coordinated Multipoint (CoMP) operation. In this example User Equipment (UE) data is
Wind Farm (IG)
Phasor simulation of a 9-MW wind farm using Induction Generators (IG) driven by variable-pitch wind turbines.
Filter a sinusoid with the Overlap-Add and Overlap-Save FFT methods using the Frequency-Domain FIR filter block.
According to LEAN thinking, a company's level of waste tells a lot about its effectiveness, its internal organization, and its strategic planning. Mantain high quality standards and low
What do you know about Electrical Stimuation?
Authors : Andrea Gargano, Paolo Seghetti, Niccolò Biasi
Approximating Nonlinear Relationships: Type S Thermocouple
Approximate nonlinear relationships of a type S thermocouple.
Simulating Automatic Climate Control Systems
Simulate the working of an automatic climate control system in a car using Simulink® and Stateflow®. You can enter a temperature value you would like the air in the car to reach by double
Simulation of a Bouncing Ball
Use two different approaches to modeling a bouncing ball using Simulink®.
Designing a High Angle of Attack Pitch Mode Control
Use the Control System Toolbox™ and Simulink® Control Design™ to interact with Simulink to design a digital pitch control for the aircraft. In this example, we will design the controller to
Anti-Windup Control Using a PID Controller
Use anti-windup schemes to prevent integration wind-up in PID controllers when the actuators are saturated. We use the PID Controller block in Simulink® which features two built-in