Answered
Command Window, display line numbers?
Hi Joshua, There is no method to configure command window in such a manner that the line number is shown corresponding to ever...

1 year ago | 0

Answered
Cannot save model 'dfig' in the MDL file format because some of characters it contains are not valid in the current character encoding, 'US-ASCII'. Either remove these charac
Hi Khelifa, The error you are facing is because of the filename with which you are trying to save the model. Check the “Choos...

1 year ago | 0

Answered
How do I incorporate a feedforward control signal into an MPC block?
Hi Joe, According to my understanding, MPC is generally used in closed loop configuration and the “Measured disturbances” is u...

1 year ago | 0

| accepted

Answered
Unable to get shared memory page. Make sure that your model either consists a Simulation step or an Analysis step block.
Hi Jie Tang, The error you are facing could be due to version mismatch between CANOE and MATLAB. The CANOE Blockset and CANOE...

1 year ago | 0

Answered
Solar PV System with MPPT Using Boost Converter
Hi Nishant, I believe you are referring to the following model present on the MathWorks documentation page - https://www.mathw...

1 year ago | 0

Answered
n-dimensional Polyhedron plotting using 2-dimensional plot commamnd
Hi Morteza, As per my understanding of the question you want to plot a “Polyhedron” in a 2-dimensional plot using only two of...

1 year ago | 0