How can i design a variable inductor for three phase inverter in simulink?
2 views (last 30 days)
Show older comments
I am trying to build variable inductor model in three phase voltage source rectifier and i have used the program for the variable inductor design i.e., "power_VariableInductor" (You can run this program in Matlab) but when i use the same design in my three phase voltage source rectifier then there comes problem in the block i.e., "Inject inductor current" and receive the message when i run the simulation i.e.
"The 'Variable Inductance1/Inject Inductor current ' block cannot be left open-circuit because it is modeled as a current source. You should try to resolve the open-circuit topology or delete this block from your model."
There is also same design used in the following paper
Please guide me about the mistake i am making in the design of variable inductor
0 Comments
Answers (3)
Adam Barber
on 11 Aug 2015
Hi Muhammad,
As the error indicates, you likely have left the "Inject Inductor Current" block open-circuit. In the "power_VariableInductor" example, this block is in the "Variable Inductance" subsystem and is closed-circuit. First, I would make sure that yours is implemented in a similar manner. If it is, please upload the model so that we can take a look.
Unfortunately, I cannot look at the paper you linked because I do not have a subscription. You may want to try and describe what they are doing a bit if the above does not help.
Best of luck,
-Adam
siwei yang
on 25 Apr 2019
Hi,I am researching this topic and having the same question,can you share your solution about this problem,thank you very much。
I will very appreciate if you can send me an email to 1405020127@s.upc.edu.cn
Thanks again!
0 Comments
See Also
Categories
Find more on Simscape Electrical in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!