Could not connect to the image acquisition device. Device may be in use.
6 views (last 30 days)
Show older comments
Hello there,
I was trying to get a video stream from my web camera genius gf112 under linux OS. I use 64-bit Gentoo and Matlab 7.12.0(R2011a). I used the following command line:
LD_PRELOAD=/usr/lib/libv4l/v4l2convert.so ./matlab
to run Matlab. After that I got a vid object using videoinput() function like shown here:
vid = videoinput('linuxvideo', 1, 'RGB3_352x288')
Summary of Video Input Object Using 'CIF Single Chip '.
Acquisition Source(s): pac207 is available.
Acquisition Parameters: 'pac207' is the current selected source.
10 frames per trigger using the selected source.
'RGB3_352x288' video data to be logged upon START.
Grabbing first of every 1 frame(s).
Log data to 'memory' on trigger.
Trigger Parameters: 1 'immediate' trigger(s) on START.
Status: Waiting for START.
0 frames acquired since starting.
0 frames available for GETDATA.
But when I tried to preview or start getting a stream from the camera
start(vid)
preview(vid)
I received the following error:
Warning: Unable to reset the crop area. Perhaps the device is
in use.
??? Error using ==> imaqdevice.preview at 181
Could not connect to the image acquisition device. Device may
be in use.
What did I do wrong?
0 Comments
Answers (1)
Mark Jones
on 15 Sep 2011
Hi Sergey,
Can you contact technical support for this issue?
Mark
0 Comments
See Also
Categories
Find more on National Instruments Frame Grabbers in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!