This example shows how to design a ladder logic scheduler in Stateflow®. The ladder logic scheduler design pattern allows you to specify the order in which multiple Simulink® subsystems execute in a single time step.
In this example, the Ladder Logic Scheduler chart broadcasts a series of function-call output events to execute three function-call subsystems (A1, A2, and A3). During each time step:
The Simulink model activates the Edge to Function chart at the rising edge of the 1-millisecond pulse generator.
The Edge to Function chart broadcasts the function-call output event
call to activate Ladder Logic Scheduler chart.
The Ladder Logic Scheduler chart uses sequencing ladder logic to broadcast function-call output events based on the values of the input signals
The chart evaluates each condition sequentially. When a condition is valid, the chart calls the
send operator to broadcast an output event. The corresponding subsystem computes its output and returns control back to the Ladder Logic Scheduler chart.
When you simulate the model, the scope shows the input and output of each function-call subsystem.
During each time step, the Ladder Logic Scheduler chart executes the subsystems depending on the values of the input signals
u1 is positive, the chart sends a function-call output event to execute subsystem A1. This subsystem multiplies the value of
u1 by a gain of 3 and passes this value back to the Ladder Logic Scheduler chart as input
u2. Control returns to the next condition in the Ladder Logic Scheduler chart.
u2 is greater than 1, the chart sends a function-call output event to execute subsystem A2. This subsystem decreases the value of
u2 by 1. Control returns to the final condition in the Ladder Logic Scheduler chart.
u2 is less than 2, the chart sends a function-call output event to execute subsystem A3. This subsystem multiplies its input by a gain of 2.
In the scope, horizontal segments indicate time steps when a subsystem does not execute.