Main Content

Using the Common Gear Block

This example models a pair of gears with parallel axes. The assembly contains the two gears and all constraints required for the gear set. The assembly can be configured to model an external or internal gear set by adjusting parameters in the mask.

Model

Common Gear Assembly Subsystem

Open Subsystem

Common Gear Assembly Constraints Subsystem

The Common Gear Constraint requires that the rest of the mechanism hold the two frames to which it is connected in alignment. This subsystem has the necessary constraints and parameterized Rigid Transform to hold the frames in the right position and orientation.

Open Subsystem

Simulation Results from Simscape Logging

The plot below shows the speeds of the two shafts connected by the common gear assembly in an external configuration.

The plot below shows the speeds of the two shafts connected by the common gear assembly in an internal configuration.

See Also

|