Default System Reference Design for AMD FPGA Board

The HDL Coder™ software can generate an IP core with an AXI4 or an AXI4-Lite interface. You can integrate the HDL IP core into the Default system reference design.

The Default system is a basic reference design that contains an ARM processor and the HDL IP core. HDL Coder generates the HDL DUT IP core, and inserts it into the reference design. The processor acts as manager, and the IP core acts as subordinate. By accessing the generated registers via the AXI4-Lite interface, the processor can read and write data to and from the IP core. You can tune the parameters on the FPGA, or probe the results from the FPGA via AXI4-Lite interface in the IP core. To tune the parameters or probe results, use this reference design with External mode in Simulink®.

To specify the Default system as the target reference design:

  1. Specify IP Core Generation as target workflow. Open the HDL Workflow Advisor. In the Set Target Device and Synthesis Tool task, specify IP Core Generation as the Target workflow.

  2. Specify Default system as target reference design. In the Set Target Reference Design task, for Reference design, select Default system.

Go through the workflow to generate the HDL IP core, and integrate the IP core into the Default system reference design.

Board Support

You can use the Default system reference design architecture with these target platforms:

  • Xilinx® Kintex-7 KC705 development board

  • Xilinx Virtex-7 VC707 development board

  • Xilinx Artix-7 35T Arty development board

See Also

Topics